1.Setting Up the Tripod
2.Attaching the Telescope Optical Tube to
the Tripod
3.Attaching the Finder to the Telescope
Optical Tube
4.Installing the Eyepiece
●How to calculate the Powers of Telescope
Focal length of Objective Lens in (mm)
= X Powers of Telescope
Focal Length of Eyepiece in (mm)
Examples:
When SKY WALKER SW-0 with 20mm eyepiece is used:
360(mm)
=18xPower
20(mm)
安全上のご注意
◆天体望遠鏡をご使用の前に◆
4
Assembly
Stand the tripod upright and pull the tripod legs apart
until each leg is fully extended (Fig-1). As necessary,
adjust the leg-length releasing the tripod extender lock
(Fig-2).
Adjust the height of tripod by extending the elevator
part by loosening the elevator locking screw.
Azimuthal Mount
Eyepiece
Eyepiece
Diagonal
Erecting prism
Finder
Mounting Image
●To observe celestial objects
●To observe objects on the ground
(Fig-1)
(Fig-2)
Tripod Extender Lock
Reverse Side
Reverse Side
Telescope
Optical Tube
Remove the caps that in front and rear of
telescope-tube. Place and fix the telescope optical
tube on the tripod using the telescope-tube locking
screw. At this time, make sure to fit the concave
part of the telescope tube and the convex part of
the mount so that the tube is aligned properly.
Attaching the telescope optical tube to the tripod
mount should be firmly secured. It is dangerous if
the tubes fall off caused by an unsecured locking
screw.
Attach the finder to the proper location on the
telescope optical tube. The finder should be aligned
before using the telescope (See page 5 for proper
aligning of the finder.).
To observe an erect image with the telescope, you
must use an eyepiece. For astronomical observation,
you should use diagonal and eyepiece. Firstly, remove
both ends of caps on diagonal, Attach the eyepiece
with the star diagonal like shown on the picture below
and tighten the locking screws. For observation object
on the ground, attach the eyepiece with the erecting
prism like shown on the picture below. (See page 6 for
attaching method)
The eyepiece can be changed to different powers.
This telescope comes with three eyepieces.
Depending on the observed object, you can select
your favorite eyepiece.
This section covers the assembly instructions for your SKY WALKER SW-0 telescope. It is highly
recommended that the first setup of the telescope should be done indoors. This way it will be easier
to identify all the various parts and familiarize yourself with the correct assembly procedure before
attempting out in the field.
Telescope Tube
Swing Locking
Screw
Telescope
Optical Tube
Telescope
Optical Tube
Locking Screws
Locking
Screws
Содержание SKY WALKER SW-0
Страница 1: ...SW 0 Operating Instructions SW 0...