8
Figure 17
Figure 18
9. ATTACHING THE FAN
BLADES
CAUTION:
Remove 5 rubber packing mounts and
discard before installation.
Step 1 Attach the blade to the blade bracket using
the screws and fiber washers as shown in Figure
17. Start screw into bracket. Repeat for the two
remaining screws.
Step 2 Tighten each screw. Make sure the blade is
straight.
Step 3 Fasten blade assembly to motor using the
screws supplied. (Fig. 17)
10. INSTALLING THE
SWITCH HOUSING
NOTE:
Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
1. Remove the screws from the mounting plate
under the fan motor.
2 . W h i l e h o l d i n g t h e s w i t c h h o u s i n g u n d e r
your fan, snap together the wire connection
plug. (Fig. 18)
3. Raise the switch housing to the mounting
plate until the holes in switch housing and
mounting plate line up. Reinsert screws to
secure in place. (Fig. 18)
Blade
Blades bracket
Screws
Fiber
washers
Screws
Screws
Switch
housing
Connection plug
