8
11. ATTACHING THE LED
LIGHT KIT
NOTE:
Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove one of the three light kit
mounting screws from the mounting plate and
loosen the other two screws. (Do not remove.)
Step 2. While holding the 21W LED light kit
under the fan motor assembly, make the 2-pin
wire connections:
- Red to white
- Black to black
Step 3. Place the key holes in the LED light kit
over the two mounting screws previously
loosened from the mounting plate. Turn the
light kit until the light kit locks in place at the
narrow section of the key holes. Secure by
tightening the two light kit mounting screws
previously loosened and the one previously
removed. (Fig. 16)
Step 4. Install the glass shade by carefully
turning it clockwise until snug.
DO NOT
OVERTIGHTEN.
(Fig. 16)
Figure 16
Screws
Glass shade
Mounting plate
Light kit
Wire connectors
