KENCO Multilift® Operation Manual
8
170 State Route 271
Ligonier, PA 15658
1-800-653-6069
B.
Place Multilift®
on an object narrower than grip and with sufficient height to
provide clearance for leg assemblies for adjustment. DO NOT ATTEMPT TO
ADJUST LEG ASSEMBLIES WHILE Multilift®
IS HANGING.
1.
Care must be taken to ensure that the lifter remains stable and
balanced during adjustment.
C.
Leg assemblies are attached to the core using ADJ. HANDLE in the following
manner:
1.
Outer Leg Assembly
is latched to
OUTER CORES
.
2.
Inner Leg Assembly
is latched to
INNER CORE.
D.
Leg assemblies are referenced to their respective core member by the spacing of the
TOOTH BLOCKS
inside the leg assembly. The leg referenced to the
INNER
CORE
has (1)
TOOTH BLOCK
indexed to contact
INNER CORE,
the leg
referenced to the
OUTER CORES
has two
(2) TOOTH BLOCKS
indexed to
OUTER CORES
.
E.
Adjust legs for a level pick.
F.
Ensure that the lifter’s components (leg assemblies, lift core, and lift assembly)
do not bind and have travel remaining after adjustment.
G.
Multiple Leg Configurations:
1.
Legs can be reversed for inside-out gripping.
2.
Legs can be used in multiples for open ended boxes. *
3.
Lift assembly can be positioned to either side of the leg assemblies to handle “L’’
shaped objects.*
4.
Custom leg and pad configurations available (extended legs, hardened points, ball
joint, etc).*
5.
Custom core lengths available.*
*
Required additional hardware not included with standard unit.
