www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
1
INSTALLATION INSTRUCTIONS
MRIPSF-480_F-7499_031919
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS
BEFORE WIRING FIXTURE. INSTALL IN ACCORDANCE WITH ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT TO
AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE.
SUPPLEMENTAL INSTRUCTIONS MAY BE LOCATED ON THE FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING
ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
MEDMASTER
™
MRIPSF SERIES
Remote Power Supply and Filter System for MRI Luminaires
This instruction sheet applies to the Kenall MRIPSF-480 Remote Power Supply & EMI Filter System. It describes the
proper mounting and wiring procedure for a typical MRI room application. A separate instruction sheet is provided
with the MRI luminaire(s). Both sheets together are intended to provide comprehensive instructions on system
installation and electrical wiring.
The remote supply & EMI filter must be installed outside the shielded MRI environment. It contains ferrous
components that can damage or interfere with MRI equipment. Complete conduit runs and wiring between
power supply, EMI filters and luminaires after all system components have been installed in their final positions.
If luminaires are intended to be dimmed (via 0-10V dimming system), then the Kenall MRIFD-1A EMI filter (or
equivalent) must be ordered and installed.
.875 KO (9)
1.125 KO (7)
2.93
2.05
2.00
2.00
8.62
END VIEW
BACK VIEW
SIDE VIEW
.88
15.18
4.05
1.05
12.00
1.60
1.29
8.10
.31 Dia. Mounting Holes (4 places)
6.00
2.67
3.25
3.00
3.25
