www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
2
INSTALLATION INSTRUCTIONS
EPC_F-4492_08318
SURFACE MOUNTING
Installation
1:
Remove spade screw, washer and sealing washer.
Remove the end cap from the end without the cable.
2:
Remove the tube and install lamps.
3:
Replace the tube and end cap. Replace the sealing
washer, washer and secure by tightening the spade
screw.
4:
Wrap the two supplied stainless steel straps around the
tube and secure by pulling the tab to lock into the slot
on the other side.
5:
Attach the two supplied stainless steel brackets to the
ceiling or structure with user supplied hardware.
6:
Mount the fixture straps
to the brackets using
the supplied screws,
washers and nuts.
Be sure no threads
are exposed after
tightening. Any exposed
threads must be covered
using appropriate user
supplied cap.
7:
Connect the cable to the appropriate electrical service.
Black wire to supply, white wire to neutral and green
wire to ground.
PENDANT MOUNTING
Mounting straps are available for either 3/8 or 1/2
pendants. These should be specified when ordering.
Check for proper straps before starting installation.
Installation
1:
Remove spade screw, washer and sealing washer.
Remove the end cap from the end without the
cable.
2:
Remove the tube and install lamps.
3:
Replace the tube and end cap. Replace the sealing
washer, washer and secure by tightening the spade
screw.
4:
Wrap the two supplied stainless steel straps around
the tube and secure by pulling the tab to lock into
the slot on the other side.
5:
Mount fixture by attaching straps to pendants,
supplied by user.
6:
Connect the cable to the appropriate electrical
service. Black wire to supply, white wire to neutral
and green wire to ground.
RE-LAMPING
Before starting any servicing, turn off the power to the
fixture and allow the lamps to cool.
1:
To replace the lamps, remove end cap, Step 1 above.
2:
Replace lamps and reinstall tube, end cap and
hardware.
For warranty information visit www.kenall.com/Resources/Certified-Performance-Warranties
For technical assistance, call 1-800-4KENALL (1-800-453-6255).
WARRANTY
CUSTOMER SERVICE
