Wood Ceiling
Wood Ceiling
INSTALLATION
Hardware needed
You will also need the following hardware, which can be purchased from your local hardware
store or electrical supply store:
Electric wire in the adequate gauge and length for your application;
Proper size fuse or breaker for your heater’s amperage;
Proper wire connectors for your application;
Fasteners appropriate for your application that are strong enough to hold the unit.
Mounting the bracket
Refer to Figures 3a and 3b.
1.
Locate a wood stud in the wood ceiling joist. If you cannot locate a wood stud, you have to
install a wood piece on the ceiling as this heater must be securely fastened.
2. Remove the mounting bracket from the heating unit by loosening bracket screws witha
wrench and slipping the handle off over the screw heads.
3. Place a washer on screws before inserting through the holes in the mounting bracket and
screw them securely into a ceiling joist.
NOTE: If you want to swivel the heater either to the right or left adding a washer to both
sides of the bracket is recommended. A longer lag bolt may be required to properlysecure
the unit. See Figure 3a.
