Microscope Set-up Guide
The Digital Comprehensive Scope 2 compound microscope can be set
up in a matter of minutes. To get the most out of this amazing tool,
follow these step-by-step instructions:
1.
After unpacking the box, take the Applied Vision™
software CD and insert it into your computer to install.
NOTE:
For a complete instruction manual of Applied Vision software,
refer to the .pdf version on the Applied Vision CD.
2.
Follow the directions to install the software. Once
completed, an Applied Vision icon should appear on
your computer’s desktop.
3.
Remove the Applied Vision CD from your computer
and restart the computer.
4.
Remove the Digital Comprehensive Scope 2 from the
plastic bag and remove the protective coverings from
the objective lenses and the eyepiece(s).
5.
Place the microscope on a flat, firm surface next to the
computer with the installed Applied Vision software.
6.
Check the coarse focus knob on either side of the main
body support. The coarse focus knobs should turn
easily.
NOTE:
The stage should move freely up and down the main body
support when focusing. When you release the knob, the stage should
remain stationary, and not slide down the post on its own.
7.
To operate the cordless feature of this microscope,
immediately plug in the microscope to charge for eight
(8) hours.
a.
Plug in the round pin adapter from the power
supply to the back of your microscope.
b.
Connect the opposite end to a Ken-A-Vision
®
multicharger (Part # SCGN061) or an 110V
(220V international) electrical outlet.
NOTE:
With one (1) overnight eight (8) hour charge, you can use the
microscope for up to forty (40) hours of continuous operation. The
cordless microscope can also be operated with the cord plugged into the
power source.
c.
The best option, when not in use, is to plug the
microscope into a Ken-A-Vision multicharger
that will automatically stop charging once the
microscope is fully charged to keep it at the
3
All manuals and user guides at all-guides.com
