MASTER 5001/0541 – 3
©
KEMPPI
OY
1. PREFACE
1.1. INTRODUCTION
Congratulations on having purchased this product. Properly installed Kemppi products should
prove to be productive machines requiring maintenance at only regular intervals. This manual is
arranged to give you a good understanding of the equipment and its safe operation. It also contains
maintenance information and technical specifications. Read this manual from front to back before
installing, operating or maintaining the equipment for the first time. For further information on
Kemppi products please contact us or your nearest Kemppi distributor.
The specifications and designs presented in this manual are subject to change without prior
notice.
In this document, for danger to life or injury the following symbol is used:
Read the warning texts carefully and follow the instructions. Please also study the Operation safety
instructions and respect them when installing, operating and servicing the machine.
1.2. PRODUCT INTRODUCTION
Master 5001 is a 3-phase inverter power source for demanding professional use. Master 5001
is suitable for MMA welding and carbon arc gouging. It is also suitable as power source for arc
powered wire feeders. Master 5001 can also be used as power source for scratch-start/contact TIG.
Due to its high effect and excellent welding properties as well as due to its small size and light
weight it is very suitable for site welding as well as for repair and production welding.
In order to enable a good following of welding current the machine is equipped with well-visible
displays for welding current and welding voltage. Properties of Master 5001 can be improved with
remote control units and transport carts which are delivered as accessory.
1.3. OPERATION SAFETY
Never watch the arc without a face shield designed for arc welding!
The arc damages unprotected eyes! The arc burns unprotected skin!
Protect yourself and the surroundings against the arc and hot spray!
Remember general fire safety!
Pay attention to the fire safety regulations. Welding is always classified as a fire risk operation.
Welding where there is flammable or explosive material is strictly forbidden. If it is essential to
weld in such an area remove inflammable material from the immediate vicinity of the welding site.
Fire extinguishers must always be on site where welding is taking place.
Note! Sparks may cause ignition many hours after completion of welding.
Watch the mains voltage!
Take care of the cables - the connection cable must not be compressed, touch sharp edges or hot
work pieces. Faulty cables are always a fire risk and highly dangerous. Do not locate the welding
machine on wet surfaces. Do not take the welding machine inside the work piece (i.e. in containers,
cars etc.)
Ensure that neither you nor gas bottles or electricial equipment are in contact with live wires or
connections!
