15
A3 MIG Welder
© Kemppi Oy 2018
1826
OPERA
TING M
ANU
AL
4.4 Optional MIG features
In addition to the standard MIG features, it is also possible to acquire optional features
that further enhance the welding.
To use the optional features, enter a machine-specific activation code in the machine's
control panel as shown below. To acquire an activation code, contact a Kemppi rep-
resentative.
Activating optional features
1.
Press and hold down the SETUP button (5) for at least 5 seconds. The
SETUP settings menu appears on the display.
2.
Select the
Cod
(cod) alternative with the left-hand side control knob
in the control panel and then select the value
Ent
(ent) using the
right-hand side control knob.
3.
Briefly press the SAVE button (11).
4.
When the display on the left-hand side reads 1 (1), enter the first value
of the activation code using the right-hand side control knob. The value
you have entered is shown in the right-hand side display.
5.
Select the entry of the next value using the left-hand side control knob.
6.
Enter the value corresponding to the value shown in the left-hand side
display using the right-hand side control knob.
7.
Repeat steps 5 and 6 until you have entered all values of the activation
code.
8.
Finally, press the SAVE button (11) briefly.
The control panel will read
Suc cEs
(success) to indicate that the activation code
has been entered correctly and the optional feature is available. You can exit the code
entry mode at any time by briefly pressing ESC.
If the code entry failed, the control panel display will show an error code. For more
information on error codes, see "Troubleshooting".
The operating instructions for optional features can be found in the documentation
supplied with the feature.
