Kemper KHS-HS2 689 03 001, Инструкция по установке и эксплуатации

Страница: 20 / 24

EN
Element Status Meaning
LED green Short blinking
pulse
In normal operation,
operating voltage on
Long blinking
pulse In normal operation,
Bluetooth interface
aktive
On Solenoid valve open
Off Operating voltage off
LED red On Fault (analysis with
KEMPER HS2 app
required)
Blinking
Warning (analysis
with KEMPER HS2 app
required)
Off In normal operation
Buzzer
On1)
Fault (analysis with
KEMPER HS2 app
required)
Off In normal operation
Button
<Test> Activated Test solenoid valves
With active
Bluetooth-interface:
Disconnect connection
At fault: snooze
buzzer
Commissioning
Requirements
The commissioning and fault analysis of the
KHS
- Hygiene Flushing Box 2 are carried out
by a smartphone and the KEMPER HS2 app.
The KEMPER HS2 app is available for
free for Android and iOS smartphones in the
respective
App Store (see QR-code).
The app communicates via Bluetooth interface
with the KHS
- Hygiene Flushing Box 2
.
Commissioning with
KEMPER HS2 app
When installed and connected, the red LED of
the KHS
- Hygiene Flushing Box 2 is blinking till
first commissioning.
1
Install KEMPER HS2 app on your
smartphone. Scan QR code or go
to hs2 a pp.kemper-olpe.de to
install.
Factory settings
The factory settings of the KHS
-
Hygiene
Flushing Box 2 are shown in table 1. This is
the valid program if nothing else is configured.
Table 1: Factory settings
Parameter Description Value
Flushing
interval
Time between two
flushings 48 h
Flushing
time
Duration of a flush 3 min
It is recommended to set up a project
specific program for the KHS - Hygiene
Flushing Box 2, as each water installation has
different characteristics.
Display of operating mode
The control unit of the KHS - Hygiene Flushing
Box 2 displays the following operating
states:
Table 2: Operating modes
2
Start KEMPER HS2 app and
perform the following steps.
3
Connect smartphone to KHS Hygiene
Flushing Box 2 via Bluetooth.
4
Enter the menu <hardware setup>.
Check the settings and change them if
required.
5
Enter the menu <operating
modes>. Configure the
operating times.
External control
The KHS - Hygiene Flushing Box 2 can be
activated externally via a KHS - Mini System
Control or a building management system.
In this case, a direct configuration is not
required. The KHS
- Hygiene Flushing Box 2 can
be set up and operated by the external control.
For more information about the
external control, please see the
documentation of the KHS
- Mini
System Control and Connection
kit's.
1) The buzzer can be put to snooze mode with the button
<TEST>. If the error still exists after 24 hours, the buzzer
is activated again.
Use the KEMPER HS2 app for fault
analysis and error acknowledgement.
KEMPER KHS - HS2 20