Kemper EVOLUTION LINE, Руководство по эксплуатации

Страница: 11 / 204

Introduction
Emil Kemper GmbH EVOLUTION LINE roll machine
3
1.3.1 General safety information
–
Do not exceed the technical performance and capacity limits.
–
Keep all safety and danger signs on the line clean and renew them if necessary.
–
The machine is only allowed to be operated by trained personnel.
–
If the line malfunctions, take it out of operation immediately. Have faults rectified by
appropriately trained personnel.
–
Follow the procedures described in this operating manual to switch the machine on
and off and watch the control indicators.
–
Do not start the line if other persons are in the danger zone.
–
Always keep the operating manual at the line's point of use.
1.3.2 Personal protective equipment
Wear the necessary personal protective equipment, e.g. safety shoes, whenever working
at the line.
These must be provided by the plant operator and must satisfy the requirements.
It is also necessary to obey national rules and the plant operator's internal instructions.
1.3.3 Safety devices and guards
–
Before switching the line on always make sure that all safety devices and guards have
been fitted properly and are functional.
–
The line's sound absorbers (panelling) must be attached during operation.
–
Guards are only allowed to be removed

after the machine has come to a standstill and

after it has been prevented from being turned on again unexpectedly (e.g. by
locking the locally installed switch).
–
When sub-components are delivered, the plant operator must ensure that the guards
are fitted according to the rules.
–
You must not bridge or remove safety devices and guards or defeat them in any other
way.