8
Owner’s manual
EN
5. LED flashlight
6. USB output port
JUMP STARTING YOUR VEHICLE
Note: Please make sure that there are at least 3 LED indicators on before
starting a car. Otherwise, it can only be used for charging external devices
or flashlight mode.
1. Please make sure the key is in the OFF position in the ignition before
starting your vehicle.
2. Ensure all electronics in your vehicle are off.
3. Make sure the jump starter is off.
4. Connect the red clamp to the positive electrode (+) of the car battery
and black clamp to the negative electrode (-).
Note: Please make sure that the power is well connected.
5. Insert the EC5 cable to the EC5 ignition output port.
6. Place the device in secure place to prevent it from falling while starting
the vehicle.
7. Turn on the device.
8. Start your vehicle.
9. After a successful start, disconnect the EC5 cable from the EC5 ignition
output port of the jump starter, then disconnect the clamps from the
car battery.
10. In case of failure to start your vehicle for the first time, wait a few
seconds before trying again and then repeat the process.
Notes:
• When the battery level of the device is too low, it cannot be used to start
the vehicle. It has to be recharged first.
• This product is only for 12 V vehicle emergency start. It cannot be used as
long- term automotive storage battery.
CHARGING USB EXTERNAL DEVICES
1. Insert one end of the USB charging cable into the USB output port of the
jump starter; insert the other end into the USB port of the USB external
device (mobile phone, tablet, laptop).
2. When the battery level of the jump starter is low, the device will
automatically end charging.
3. The USB port of the device has anti short-circuit function.
4. When the USB external device is fully charged, the device will automatically
enter sleep mode in 30 seconds without any operation.
5. When the USB cable is disconnected, the device will automatically enter
sleep mode in 3 seconds without any operation.
