Kelvinator KTM4602WAR, Руководство пользователя

Страница: 6 / 16

Unpacking
ENVIRONMENTAL TIPS
environment
Most of the packing materials are recyclable. Please dispose
of those materials through your local recycling depot or by
placing them in appropriate collection containers.
TIPS & INFORMATION
important
Check for any damages or marks. If you find the refrigerator is
damaged or marked, you must report it within 7 days should
you wish to claim for damage/ marks under the manufacturers
warranty. This does not affect your statutory rights.
Clean your refrigerator thoroughly following the instructions in
the “Cleaning the refrigerator” section and wipe off any dust
that has accumulated during shipping.
Locating the refrigerator
WARNING
caution
Automatic aerosol systems (such as insect control) should not
be located adjacent to the product as the spray may cause long
term damage to the external plastics of the appliance.
Do not put the refrigerator in a location that is too cold or is
unprotected, for example in a garage or on a veranda. The
ambient temperature should be above 10°C.
Put the refrigerator in a dry place avoiding areas of high
moisture or humidity.
Ensure the refrigerator is located on an even surface.
Adequate ventilation around your refrigerator
The diagram below shows the recommended airspace to allow
for ventilation of your refrigerator.
Recommended
airspace
Cabinet
door
50mm
X
Y
30mm 30mm
350mm
If you have a cupboard above the refrigerator with a rear gap of
less than 100 mm (Y), recommended clearance at the top of the
refrigerator increases from 50mm to 90mm (X) minimum.
When positioned in a corner area, spacing of at least 350mm
(300mm for multi-door models) on the hinge side will allow
the doors to open enough to enable the removal of bins and
shelves.
NOTE: Doors are designed to sit proud of cabinetry (not flush).
The clearances shown above are the recommended minimum
clearances.
The clearance at the rear must not exceed 75mm.
Installing your new appliance
Installing your refrigerator
1. Roll the refrigerator into place.
The rollers are designed for forward or backward
movement only. They are not castors. Moving the
refrigerator sideways may damage your floor and the
rollers. Before moving your refrigerator ensure height
adjusting nut and the stability foot are fully wound up off
the floor.
2. Wind the large height adjusting nut under door hinge
down until the refrigerator is tilted back by 10mm
(see diagram).
Height adjusting nut
Fixed rear rollers
10-15mm
3. Wind the large height adjusting nut on the handle side
down until the refrigerator is level and stable. If you have
difficulty winding the nut or height adjusting foot down,
have someone tilt the refrigerator back so you have better
access.
Stability foot
wound up
4. Check the alignment of the refrigerator to the surrounding
cupboards to see if it is level. You can adjust the level as
detailed in step 2 and 3.
Aligned to
cupboards
ie. even gap
Top of refrigerator is
level ie. horizontal
Adjust front feet for
unevenness of floor
e.g. wind this foot
down or up
6
Installation