Kelon Inverter Multi-Split Type Room Air Conditioner, Инструкция по использованию и уходу

Страница: 78 / 80

4. Connecting of the Cable
Indoor Unit
Connect the connecting cable to the outdoor unit
by connecting the wires to the terminals on the control
board individually in accordance with the outdoor unit
connection.
Chassis
Cabinet
Front panel
Cable Specifications
Note: For some models, it is necessary to remove the cabinet to
connect to indoor unit terminal.
Terminal (inside)
Indoor unit
Installation instructions
Caution:
1. Never fail to have an individual power circuit specifically for the air conditioner. As for the method of
wiring, refer to the circuit diagram posted on the inside of the access door .
2.Confirm that the cable thickness is as specified in the power source specification.
(See the cable specification table below)
3.Check the wires and make sure that they are all tightly fastened after cable connection.
4. Be sure to install an earth leakage circuit breaker in wet or moist area.
The figures in this manual are based on the external
view of a standard model. Consequently, the shape
may differ from that of the air conditioner you have
selected.
36
Attention:
Accessibility to the plug must be guaranteed even after the installation of the appliance to disconnect
it in case of need. If not possible, connect appliance to a double-pole switching device with contact
separation of at least 3 mm placed in an accessible position even after installation.
Connecting
cable to outdoor unit
Terminal
Indoor and outdoor
connecting wire specification
2
Cable 4-core 0.75mm , in conformity with
Design 245 IEC 57.
Indoor unit
Outdoor unit
1(L)
1(L)
2(N)
2(N)
3
4(SI)
4(SI)
1 ( L ) 2
( N )
3 4 ( SI )