4
9
in THe field TiP for usinG your mP5 Pro deTeCTor
2. Correct arm position.
Adjust the lower stem so that your arm
is hanging in a comfortable position by your side with the coil
about 1 inch off the ground.
1. Always keep the bottom of the coil level with the ground.
Try
to maintain coil 1 inch off the ground at all times. You do not need
to scrub the ground with the coil.
insTallinG THe BaTTeries –
1/4" HEADPHONE JACK
Installing the Batteries:
Re-
move the battery compart-
ment cover and install two (2)
9-volt batteries. Make the cor-
rect connections between the
new batteries and ensure the
battery snaps are plugged in.
Replace the battery cover.
Battery Door Cover
DISCRIMINATE
VOLUME
ON / OFF
SENSITIVITY
PINPOINT
5
MP
PRO
High Performance – Deep Searching
0
1
3
2
4
5
6
7
8
9
10
PRE SET
PRE SET
0
1
3
2
4 5
6
7
8
9
10
0
1
3
2
4
5
6
7
8
9
10
PRE SET
automatic led (red light):
The MP5 Pro has built-in automatic LED
battery test light that will start to glow red when the batteries reach a volt-
age point that is too low for maximum performance. At first turn-on the LED
might flicker some, then go out. This is normal. Only when the MP5 Pro is
on and the batteries start to lose their charge will the LED begin to glow
Red. When this happens it is time to replace both batteries. (You may still
be able to use the detector for a short while longer.) Only use fresh high
quality alkaline type.
Note:
If using rechargeable types your run time will be somewhat less than
standard alkaline types.
Automatic LED
(Red Light)