Kellfri 27-EA52, Руководство пользователя, Страница: 10 / 16

10
STEPS TO TAKE BEFORE USE
• Fill with fuel. Ensure that you use the right mix (25:1) of petrol and 2-stroke oil to avoid
damaging the engine.
• Inspect the work area before starting work and remove objects that can cause accidents.
Make sure that there are no underground power lines or water pipes in the area to be drilled.
• Always check that the air filter is not dirty or clogged, as this will increase fuel consumption.
THINGS TO CONSIDER DURING USE
• Do not accelerate the engine too quickly as this will cause wear and tear. Wait until the engine
has reached the correct working temperature before starting work.
• This auger is intended for drilling in earth. Never attempt to drill solid material such as wood,
stone or metal.
• Avoid working continuously for many hours; take occasional breaks to avoid contracting
vibration white finger (VWF) caused by vibration.
STARTING THE ENGINE
1. Fill the tank with fuel if required.
2. Place the drill tip on the ground to start.
3. Press the primer pump several times until it
is filled with fuel. You should be able to see
the fuel through the transparent fuel hose.
4. Put the choke in the “ON” position
(only used when the engine is cold)
5. Put the on/off button into the “ON” position
6. Hold the machine steady and quickly pull the
recoil starter rope. Repeat until the engine starts.
7. If the engine has been flooded with fuel, unscrew the spark plug and wipe with a clean rag.
Screw the spark plug back in and repeat the previous step, but only after turning off the choke.
8. Always run the engine at a low speed for 3-5 min to allow it to warm up. Gradually move the
choke back to the OFF position.
TURNING OFF THE ENGINE
1. Release the gas.
2. Put the on/off button into the “OFF” position
3. Do not place the machine close to combustible material while the engine is still hot.
4. Empty the engine of fuel if the machine is not to be used for a long period of time.
Warning!
NEVER touch the cutting edge while the engine is running. To avoid injury,
always turn the engine off before YOU do any work on the machine.