16
CHANGING FREQUENCY BANK
The transmitter is preset in Channel 1 Bank 1
The frequency bank is changed in the transmitter before it is paired with the receiver. If a
receiver has already been paired with the transmitter, the receiver must be deleted and the
frequency bank changed before the transmitter can be paired again.
IMPORTANT! The transmitter must be off when switching between banks.
1. a.) Remove the lock belt clip
b.) Remove the battery cover
2. a.) Take out the batteries (3) and dismantle
the battery casing.
b.) The frequency buttons are located to
the left of the circuit board.
3. Check the frequency table and select the
frequency bank you wish to use. Set the buttons
(see figure) in the correct position in line with the
frequency button table above.
4. Then reassemble all the parts.
