8
TRANSPORT AND STORING
Check that the work area is free from bystanders, children and objects before driving off. Al-
ways observe additional caution during transport and moving. Ensure that the equipment or
product is well anchored and existing transport lashings are fitted. Always position the load as
low as possible. Respect the risk zone even during transport and moving. Do not permit any-
one to walk under suspended loads when carrying out lifts. Trailers used for transport should
have properly working brakes. Always keep the equipment or product on a dry surface, prefer-
ably underneath a roof when not in use. Ensure that the equipment or product is stable and
cannot fall over. Never permit children to play at the storage site. Be aware of the tipping risk!
If the chipper is to be stored for a long time, lubricate the knives with lubricants.
MAINTENANCE AND SERVICE
Ensure that the unit is stable and cannot tip over during maintenance and service. Replace
damaged or worn parts immediately to reduce the risk of abrasion. Always perform mainte-
nance, service and inspection, as recommended. Use only original replacement parts or spare
parts with equivalent performance to reduce the risk of damage
•
Always disconnect the implement from the tractor when the fault remedied.
•
May only raise in the special lifting points, only use lifting equipment with sufficient lift-
ing capacity.
•
Regularly check the condition of the the implement before the break down is a fact. If you
discover cracks, twisting, bending, gaps or fatigue stop the operation and rectify the fault.
•
Worn parts should be replaced. Tighten all screws and nuts after a few hours of driving,
and after a day of using the implement.
•
Check all bolts and nuts are tightened after maintenance and service. Always test the
machine before opeartion is started.
•
Lubricate all lubrication points regularly. Lubrication points are lubricated every 20 hours.
RECYCLING
Disposal of the product, disassemble and transport to the municipality’s recycling station.
Contact your local authority for further information
SERVICE
INTERVALL
Knives
Before each run
Replace any defective blades. Sharp blades provide better
results. When replacing bolts, tightened them properly.
While driving
listen for noises
Bearings
Regularly
Aftter 50 running hours
lubricate bearings with grease regularly, depending on
how much the machine is used. When the machine is
oftenly use, all bearing should be lubricated every week.
Otherwise, every 50 hours or once a year.
The implement
After each run
Wash away dirt and grass with water
Safety equippment
Before each run
Check of safety devices such as safety valves, safety etc.
