KELE • www.kele.com • FAX 800-284-5353
USA 888-397-5353 • International 901-382-6084
3
ACTION INSTRUCTION
VERIFICATION
On
Press button #1 down until "Output
0 mA/VDC LED will be
LEDs" ramp up and back full scale
continuously lit
(Figure 1a)
Off
Press buttons 2, 3, & 4 simultaneously
All LEDs will turn off
(Figure 1b)
FIGURE 1a
FIGURE 1b
Power On/Off
SET-UP INSTRUCTIONS
ACTION INSTRUCTION
VERIFICATION
Increase Output
Press button #4
"Output LED" will increase
(Figure 2)
to the next output level
Decrease Output
Press button #1
"Output LED" will decrease
(Figure 2)
to the next output level
FIGURE 2
Selecting the Output Level
The Ramping Function
The ASG will continuously ramp between two user-defined endpoints for a user-specified interval time between
each incremental step. The ASG is preprogrammed to ramp between 4 mA (2 VDC) and 20 mA (10 VDC) in 10-
second increments; however, custom incremental times and end points can be temporarily programmed into the
ASG.
ACTION INSTRUCTION
VERIFICATION
Set Starting Point
Press buttons #1 or 4 to
Appropriate "Output LED"
desired starting output level
will light
(Figure 3a)
Start Ramping
Press and hold buttons #2 & 3
"Status LED" and "Output
(Figure 3b)
LED" will blink alternately
Stop Ramping
Press buttons #2 & 3
"Status LED" will stop blinking &
(Figure 3c)
turn off, "Output LED" will light
continuously
FIGURE 3a FIGURE 3b FIGURE 3c
Ramping Start and Stop
Press and Release
Press and hold until
action has occurred
Press either
highlighted button