Series 2600B System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2600BS-901-01 Rev. B / May 2013
7-47
Example
MaxCount = dataqueue.CAPACITY
while dataqueue.count < MaxCount do
dataqueue.add(1)
end
print("There are " .. dataqueue.count
.. " items in the data queue")
dataqueue.clear()
print("There are " .. dataqueue.count
.. " items in the data queue")
This example fills the data queue and prints the
number of items in the queue. It then clears the
queue and prints the number of items again.
Output:
There are 128 items in the data
queue
There are 0 items in the data queue
Also see
dataqueue.add()
(on page 7-45)
dataqueue.CAPACITY
dataqueue.count
(on page 7-47)
dataqueue.next()
(on page 7-48)
dataqueue.count
This attribute contains the number of items in the data queue.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Power cycle
Not saved
Not applicable
Usage
count
= dataqueue.count
count
The number of items in the data queue
Details
The count gets updated as entries are added with
dataqueue.add()
and read from the data queue with
dataqueue.next()
. It is also updated when the data queue is cleared with
dataqueue.clear()
.
A maximum of
dataqueue.CAPACITY
items can be stored at any one time in the data queue.
Example
MaxCount = dataqueue.CAPACITY
while dataqueue.count < MaxCount do
dataqueue.add(1)
end
print("There are " .. dataqueue.count
.. " items in the data queue")
dataqueue.clear()
print("There are " .. dataqueue.count
.. " items in the data queue")
This example fills the data queue and prints the
number of items in the queue. It then clears the
queue and prints the number of items again.
Output:
There are 128 items in the data queue
There are 0 items in the data queue
Also see
dataqueue.add()
(on page 7-45)
dataqueue.CAPACITY
dataqueue.clear()
(on page 7-46)
dataqueue.next()
(on page 7-48)
Содержание System SourceMeter 2601B
Страница 841: ......