Keithley System SourceMeter 2601B, Справочное руководство

Страница: 221 / 864

Section 3: Functions and features Series 2600B System SourceMeter® Instrument Reference Manual
3-86 2600BS-901-01 Rev. B / May 2013
To write-protect specific digital I/O lines to prevent their values from being changed:
1. Press the
MENU
key, then select , and then press the
ENTER
key or the navigation wheel .
2. Select
WRITE-PROTECT
, and then press the
ENTER
key or the navigation wheel .
3. Set the decimal value as required to write-protect digital I/O lines within the range of 0 to 16,383
(see Digital I/O bit weighting (on page 3-86)), and then press the
ENTER
key or the navigation
wheel .
For example, to write-protect digital I/O lines 4 and 10, set the value to 520.
4. Press the
EXIT (LOCAL)
key as needed to return to the main menu.
To remove write protection, reset the decimal value to include only the lines that you want to write
protect. To remove write protection from all lines, set the value to 0.
Digital I/O bit weighting
Bit weighting for the digital I/O lines is shown in the following table.
Digital bit weight
Line # Bit Decimal weighting Hexadecimal weighting
1 B1 1 0x0001
2 B2 2 0x0002
3 B3 4 0x0004
4 B4 8 0x0008
5 B5 16 0x0010
6 B6 32 0x0020
7 B7 64 0x0040
8 B8 128 0x0080
9 B9 256 0x0100
10 B10 512 0x0200
11 B11 1,024 0x0400
12 B12 2,048 0x0800
13 B13 4,096 0x1000
14 B14 8,192 0x2000
Remote digital I/O commands
Commands that control and access the digital I/O port are summarized in the following table. See the
TSP command reference (on page 7-1) for complete details on these commands. See the following
table for decimal and hexadecimal values used to control and access the digital I/O port and
individual lines. Use these commands to trigger the Series 2600B using external trigger pulses
applied to the digital I/O port, or to provide trigger pulses to external devices.
Use these commands to perform basic steady-state digital I/O operations such as reading and writing
to individual I/O lines or reading and writing to the entire port.
The digital I/O lines can be used for both input and output. You must write a 1 to all digital I/O lines
that are to be used as inputs.