1-14 Getting Started
Series 2600 System SourceMeters Reference Manual
2600S-901-01 Rev. A / May 2006
Return to
Fuse replacement
A rear panel fuse drawer is located below the AC receptacle (refer to
This fuse protects the power line input of the instrument. If the line voltage fuse
needs to be replaced, refer to
.
Power-up sequence
On power-up, the Series 2600 performs self-tests on its ROM, NVRAM, and RAM
and momentarily lights all segments and annunciators. If a failure is detected, the
instrument momentarily displays an error message and the ERR annunciator
turns on. (Error messages are listed in
NOTE
If a problem develops while the instrument is under warranty, return it to
Keithley Instruments, Inc., for repair.
Assuming no errors occur, the Series 2600 will power-up as follows:
• After a few seconds with the OUTPUT indicators and display pixels on, the
instrument model number, firmware revision levels, and line frequency
setting are briefly displayed.
• The node and the GPIB address are displayed briefly as follows:
KEITHLEY MODEL 26xx
1
NODE = 1
GPIB = 26
• The node and serial port parameters are displayed briefly:
KEITHLEY MODEL 26xx
3
NODE = 1
SERIAL = 9600,8,N,1,NONE
• If the line frequency setting is AUTO, a screen will be displayed indicating
the power line frequency is being detected.
System identification
Serial number, firmware revision, and calibration dates can be displayed by selecting
the SERIAL# item of the main menu (press MENU > GENERAL > SYSTEM-INFO).
Select FIRMWARE, SERIAL#, or CAL as desired.
For remote programming, use the
*IDN?
query to read system information.
1. Unit displays actual model number: 2601, 2602, 2611, or 2612.
Содержание SourceMeter 2600 Series
Страница 507: ...AppendixA Specifications Appendix A topics Model 2600S Specifications page A 2 2600S 901 01 Rev A May 2006...
Страница 575: ...AppendixF DisplayCharacterCodes Appendix F topics Introduction page F 2...
Страница 592: ......
Страница 593: ......