![background image](http://html1.mh-extra.com/html/keithley/sourcemeter-2600-series/sourcemeter-2600-series_reference-manual_4098633211.webp)
Series 2600 System SourceMeters Reference Manual
Source-Measure Concepts
8-5
Return to
2600S-901-01 Rev. A / May 2006
Pulse sweeps
The Series 2600 can also perform the following pulse sweeps:
• Fixed voltage pulse
• Fixed current pulse
These sweeps are similar to those discussed above, except, the source level at
each sweep step is a pulse instead of a constant level. The pulse width (on time)
and pulse delay (off time) can be programmed for each type of pulse mode
sweep.
shows an example of a three-pulse sweep. See “
” described later in this section for more
information.
Pulse sweeps are used in applications where thermal response is measured or
where sustained power levels can damage the external Device Under Test (DUT).
Figure 8-2
Pulse sweep example
Pulse
On
Time
Measure
#1
Point #1
(Start)
Pulse
Off
Time
Pulse
On
Time
Measure
#2
Point #2
Pulse
Off
Time
Pulse
On
Time
Point #3
(Stop)
Measure
#3
Pulse
Off
Time
Bias
Содержание SourceMeter 2600 Series
Страница 507: ...AppendixA Specifications Appendix A topics Model 2600S Specifications page A 2 2600S 901 01 Rev A May 2006...
Страница 575: ...AppendixF DisplayCharacterCodes Appendix F topics Introduction page F 2...
Страница 592: ......
Страница 593: ......