5-2
Sweep Operation
Series 2600 System SourceMeters Reference Manual
2600S-901-01 Rev. A / May 2006
Return to
Overview
Section overview
Following a brief “
” of the types of sweeps (linear staircase,
logarithmic staircase, custom, and pulse), the documentation in this section
provides detailed information on characteristics, commands, and programming for
each type of sweep as follows:
•
•
•
•
Sweep overview
As shown in
, the Series 2600 SourceMeter can generate several types
of sweeps using the factory sweep scripts.
Linear staircase sweep
– With this sweep type, the voltage or current increases
or decreases in specific steps, beginning with a start current and ending with a
stop current.
shows an increasing linear staircase sweep.
Logarithmic staircase sweep
– In this case, the current or voltage increases or
decreases logarithmically, beginning with a start voltage or current and ending
with a stop voltage or current.
shows an increasing logarithmic
staircase sweep.
Custom (list) sweep
– The custom sweep allows you to program arbitrary sweep
steps anywhere within the output voltage or current range of the Series 2600.
shows a typical custom sweep with arbitrary steps.
Pulse sweeps
– Two sweeps can also be performed as a pulse sweep: fixed
current pulse or fixed voltage pulse. These pulse sweeps are similar to those
outlined above except that a pulse of a specific width is generated at each point
instead of a constant level.
Содержание SourceMeter 2600 Series
Страница 507: ...AppendixA Specifications Appendix A topics Model 2600S Specifications page A 2 2600S 901 01 Rev A May 2006...
Страница 575: ...AppendixF DisplayCharacterCodes Appendix F topics Introduction page F 2...
Страница 592: ......
Страница 593: ......