2.
Connect two wires from either the front panel binding posts, as shown in Figure 2 below, or the
rear panel DRIVE+ and DRIVE- terminals to your device under test.
Figure 2 Connecting a Device to the Front Panel
OPTION 2
Using Remote Sense (Lead Wire Resistance Compensated)
1.
Remove any jumpers or the shorting clip on the rear panel terminal strip connectors between
DRIVE+ and SENSE+ and between DRIVE- and SENSE-.
2.
Connect a pair of leads from SENSE+ and SENSE- to the device under test as shown in Figure 3
below. (NOTE: To assure system stability, use a jacketed, twisted-pair cable between the
remote sense terminals of the Series 2200 and the load.)
3.
Connect a pair of leads from the DRIVE+ and DRIVE- to the device under test as shown, again, in
Figure 3.
Figure 3 Connecting a Device to the Rear Panel
