8
KUSB-488B-903-01 Rev. A / March 2010
Model KUSB-488B USB to GPIB Converter Quick Start Guide
Troubleshooting
If your system does not display the Found New Hardware Wizard after you plug the Model KUSB-488B
cable into a USB port on your computer, unplug the cable and plug it into a different USB port (or plug
it into the same port again).
If the Found New Hardware Wizard does not start after you have reconnected the USB connector to
your computer, you can initiate the wizard manually.
To manually initiate the Found New Hardware Wizard:
1.
Select
Start > Settings > Control Panel
, and then double-click
Add Hardware
. The Add
Hardware Wizard dialog box displays (see
Figure 10
).
Figure 10: Add Hardware Wizard dialog box
2.
Click
Next
. The wizard then searches for any new hardware that has not yet been installed.
•
If the wizard finds new hardware:
The Found New Hardware wizard will display. Click
Next
and follow the prompts (instructions are also listed in the
Hardware installation procedure
above).
•
If the wizard does not find any new hardware:
Turn your computer off, and then turn it on
again. Once it has rebooted, the Found New Hardware wizard should launch.
Using the Keithley GPIB Configuration Utility
The Keithley GPIB Configuration Utility, which is part of the KI-488 driver package, allows you to
configure the following settings:
•
KUSB-488B bus address
•
Bus timing
•
I/O timeout
•
Set the KUSB-488B to be a system controller
•
Enable autopolling
To launch the configuration utility:
1.
From Microsoft Windows, select
Start > All Programs
.
2.
From the programs selection, select
Keithley Instruments > KI-488 > KI-488 Configuration
Utility
. The Keithley GPIB Configuration Utility window will open (see
Figure 11
).
Содержание KUSB-488B
Страница 2: ... ...
Страница 4: ...This page left blank intentionally ...