In this section:
Introduction .............................................................................. 4-1
Equipment required to run the example ................................... 4-1
Configure Model 707B or 708B for Model 4200-SCS ............... 4-1
Add Model 707B or 708B to Model 4200-SCS ......................... 4-2
Next steps ................................................................................ 4-3
Introduction
You can connect the Model 4200 Semiconductor Characterization System to a Model 707B or 708B.
This enables the Model 4200-SCS to automate measurements to multiple devices for DC, CV, and
pulsed I-V characterization.
This section describes:
•
How to configure the Model 707B or 708B for use with the Model 4200-SCS
•
How to add the Model 707B or 708B to a Model 4200-SCS
•
Where to look for more information
Equipment required to run the example
To run this test, you will need the following equipment:
•
One Model 4200-SCS instrument
•
GPIB cable to connect the Model 707B or 708B to the Model 4200
•
Model 707B or 708B and associated switch cards
Configure Model 707B or 708B for Model 4200-SCS
To use the Model 707B or 708B with the Model 4200-SCS, first configure the Model 707B or 708B to
use compatible Model 707A commands:
1. Press
MENU
.
2. Select
DDC
.
3. Select
ENABLE
.
4. Select
70xA-VERSION
. The instrument displays the message “
Must Power Cycle for DDC
to enable
."
Section 4
Working with the Model 4200-SCS
