Model 4299-4 Universal Dual Unit Rack Mount Kit Installation Instructions
PA-942 Rev. B / February 2008
3
Step 2: Install mounting hardware on instrument
NOTE
The instrument may be installed on the rack’s right side with the half-rack front panel
on the left side, as shown in the following illustrations, or on the rack’s left side with
the half-rack front panel on the right side (not shown).
1. Determine and select the unit’s side that is to be installed closest to the rack rail (see note above).
2. Place the instruments side-by-side as they will be installed in the rack (see Figure 2).
3. Secure front rack ear (2602-355) using two pan-head screws (see Figure 2).
NOTE
Knuckles on the hinge (2602-328) must face the front of the units being installed.
Figure 2
Attach rack ear and hinge to instrument
RANGE
AMPS
350V
PEAK
AU
TO
SHIFT
LOCAL
PO
WER
RANGE
HOLD
CONFIG
HAL
T
Integra Series
Pan Head Screw (Phillips)
2 Places(See Note**)
Pan Head Screw (Phillips)
2 Places
(See Note**)
Front Rack Ear
(2602-333)
RANGE
AMPS
350V
PEAK
AU
TO
SHIFT
LOCAL
PO
WER
RANGE
HOLD
CONFIG
HAL
T
Integra Series
Flat Head Screw (Phillips)
2 Places on each(See Note**)
Hinge
(2602-328)
Front Rack Ear
(2602-333)
Pin
(FA-352)
Front
Mounting
Holes
Rear
Mounting
Holes
Note:
**When installing a 2100-DMM or Agilent unit, use
M4x12 screws in the front mounting holes; otherwise
use 8-32x3/8 screws in rear mounting holes.
4. Secure one-half of the hinge to the right instrument and the other half of the hinge to the left instrument,
using two flat-head screws on each half. Check knuckle orientation on hinges; knuckles must face the front
of the units.
5. Bring the two instruments together and secure by inserting the pin (FA-352) to assemble the hinge.
Front rack ear
(2602-355)
Front rack ear
(2602-355)
**When installing a Model 2100 DMM or Agilent unit,
use M4x12 screws in the front mounting holes;
otherwise use #8-32x3/8 screws in the rear mounting
holes.
Pan-head screw (Phillips)
2 pieces
(See note**)
Pan-head screw (Phillips)
2 pieces (See note**)
Flat-head screw (Phillips)
2 places on each (See note**)
Hinge knuckle
Front
mounting
holes
Rear
mounting
holes
