Keithley 2790, Справочное руководство

Страница: 290 / 568

Model 2790 SourceMeter Switch System Reference Manual 10-7
General bus commands
General commands are those commands, such as DCL, that have the same general mean-
ing regardless of the instrument.
Table 10-1 lists the general bus commands.
REN (remote enable)
The remote enable command is sent to the Model 2790 by the controller to set up the
instrument for remote operation. Generally, the instrument should be placed in the remote
mode before you attempt to program it over the bus. Setting REN true does not place the
instrument in the remote state. You must address the instrument to listen after setting REN
true before it goes into remote.
The Model 2790 must be in remote in order to use the following commands to trigger and
acquire readings:
• INITiate and then FETCh?
• READ?
• MEASure?
Table 10-1
General bus commands
Command Effect on Model 2790
REN Goes into effect when next addressed to listen.
IFC Goes into talker and listener idle states.
LLO LOCAL key locked out.
GTL Cancel remote; restore Model 2790 front panel operation.
Cancel remote; restore front panel operation for all devices.
DCL Returns all devices to known conditions.
SDC Returns Model 2790 to known conditions.
GET Initiates a trigger.
SPE, SPD Serial polls the Model 2790.