![background image](http://html2.mh-extra.com/html/keithley/2657a/2657a_reference-manual_4007750528.webp)
Model 2657A High Power System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2657A-901-01 Rev. B/December 2012
7-215
Details
This read-only attribute contains the source compliance state (
true
or
false
).
•
true
indicates that the limit function is in control of the source (source in compliance).
•
false
indicates that the source function is in control of the output (source not in compliance).
Writing to this attribute generates an error.
Reading this attribute also updates the status model and the front panel with generated compliance information.
See Current Limit (ILMT) shown in the status model diagram for the
(on page E-8).
The Voltage Limit (VLMT) is not shown in the status model diagram for the
page E-8), but is similar to the Current Limit (ILMT).
Example
compliance = smua.source.compliance
print(compliance)
Reads the source compliance state
for SMU channel A.
Output:
true
This output indicates that a
configured limit has been reached
(voltage, current, or power limit).
Also see
(on page 7-218)
smuX.source.delay
This attribute contains the source delay.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
SMU reset
Instrument reset
Recall setup
Not saved
0 (smuX.DELAY_OFF)
Usage
sDelay
= smu
X
.source.delay
smu
X
.source.delay =
sDelay
sDelay
Set to the source delay value (for example, to specify an additional 10 ms source
delay, set the value to
0.010)
Alternatively, you can set it one of the following values:
0
or
smu
X
.DELAY_OFF
: No delay
-1
or
smu
X
.DELAY_AUTO
: Automatic delay value
X
Source-measure unit (SMU) channel (for example,
smua.source.delay
applies
to SMU channel A)
Details
This attribute allows for additional delay (settling time) after an output step. Set
sDelay
to a user-defined value
(in seconds). Alternatively, set
sDelay
to
smu
X
.DELAY_OFF
or
smu
X
.DELAY_AUTO
.
The
smu
X
.DELAY_AUTO
setting causes a range-dependent delay to be inserted when the source is changed.
Range-dependent delays are based on the output settling time values as defined in the Model 2657A
specifications.
Содержание 2657A
Страница 3: ......