2606B System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2606B-901-01 Rev. B / May 2018
7-113
Also see
(on page 7-122)
lan.config.dns.address[N]
Configures DNS server IP addresses.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
LAN restore defaults
Nonvolatile memory
"0.0.0.0"
Usage
dnsAddress
= lan.config.dns.address[
N
]
lan.config.dns.address[
N
] =
dnsAddress
dnsAddress
DNS server IP address
N
Entry index (1 or 2)
Details
This attribute is an array of DNS (domain name system) server addresses. These addresses take
priority for DNS lookups and are consulted before any server addresses that are obtained using
DHCP. This allows local DNS servers to be specified that take priority over DHCP-configured global
DNS servers.
You can specify up to two addresses. The address specified by 1 is consulted first for DNS lookups.
dnsAddress
must be a string specifying the IP address of the DNS server in dotted decimal
notation.
Unused entries are returned as
"0.0.0.0"
when read. To disable an entry, set its value to
"0.0.0.0"
or the empty string
""
.
Although only two addresses may be manually specified here, the instrument will use up to three
DNS server addresses. If two are specified here, only one that is given by a DHCP server is used. If
no entries are specified here, up to three addresses that are given by a DHCP server are used.
Example
dnsaddress = "164.109.48.173"
lan.config.dns.address[1] = dnsaddress
Configure DNS address 1 to
"164.109.48.173"
Also see
(on page 7-114)
(on page 7-122)