KL24334
–
RAPT Bluetooth Thermometer Instruction Manual
Page
5
of
7
Last Updated 25/08/2022 17:23 PM
Bluetooth Bonding to a RAPT Device
To utilise the Bluetooth functionality of the RAPT Bluetooth Thermometer you will need to bond it
via Bluetooth to a RAPT Temperature Controller, RAPT Fermentation Chamber or Gen 4 BrewZilla
Controller. Follow the steps below to bond your RAPT Bluetooth Thermometer to a RAPT enabled
device:
1.
On your RAPT Temperature Controller, RAPT Fermentation Chamber or Gen 4 BrewZilla
enter the
Menu
and navigate to
Settings
and
press ‘Select’ on the
Bluetooth enabled
setting
to enable Bluetooth on the controller.
2.
On your RAPT Temperature Controller, RAPT Fermentation Chamber or Gen 4 BrewZilla
enter the
Menu
and navigate to Bluetooth, then navigate to
RAPT Temp [Temperature]
shown in the unbonded devices
. Press
Select
and when prompted press
Select
again to
bond to this device.
You can successfully bond multiple RAPT Bluetooth Thermometers with your RAPT enabled
controller as per normal. Each RAPT Bluetooth Thermometer has a unique mac address which is
displayed in the Bluetooth settings when the thermometer is powered on.
Setting the RAPT Bluetooth Thermometer to be the
controlling temperature sensor
The RAPT Bluetooth Thermometer can be set as the controlling temperature sensor of your RAPT
Controller. To set the RAPT Bluetooth Thermometer as the controlling temperature sensor follow
the instructions below.
1.
Bond the RAPT Bluetooth Temperature Controller to your
2.
Go to
Settings
on the RAPT Temperature Controller, RAPT Fermentation Chamber or Gen 4
BrewZilla Controller
3.
Navigate to
Select Temperature Sensor
and press
Select
. Then use the up or down buttons
to scroll through the available bonded devices until your RAPT Temp is selected. Then press
Select
to confirm the setting of the RAPT Bluetooth Thermometer as being the controlling
temperature sensor.
Once you have set the RAPT Bluetooth Thermometer as the controller temperature sensor your
RAPT Temperature Controller, RAPT Fermentation Chamber or Gen 4 BrewZilla will then cycle the
heating or cooling (if applicable) on, according to the temperature measured by the RAPT Bluetooth
Thermometer and not by the built-in probe on the RAPT Controller or BrewZilla.
