RAPT Fermentation Chamber Instruction Manual
Page
7
of
13
www.KegLand.com.au
Last Updated 1/03/2022 4:36 PM
For detailed instructions showing how to install a duotight BlowTie Spunding Valve or Inline
Regulator, then please refer to the following instructional YouTube video:
duotight BlowTie Spunding Valve/Inline regulator installation video
Note
: To ensure correct orientation install the Inline Regulator (KL15035) on the left hand side.
Install the Blowtie spunding valve (KL15042) on the right hand side of the RAPT Fermentation
Chamber.
REMOVING PANEL TO ACCESS THE DRIP TRAY
The front panel at the base of the RAPT Fermentation Chamber is dismountable. In normal use it is
held in place by magnets, to allow easy and convenient access to the drip tray which is mounted
underneath the fermentation chamber. It is recommended to regularly check the drip tray and
empty as required.
To enable this, remove the four screws holding the front panel in place.
LEAK TEST PROCEDURE
Prior to beginning fermentation or hooking up any kegs to your gas line into the fermentation
chamber it is essential to conduct a leak test.
It is best to conduct a pressure decay test on the fermenter itself and on the incoming gas line into
the duotight inline regulator from the CO2 cylinder and regulator to ensure your entire system has
no leaks.