G40 with 4 x Submersible Pumps Instruction Manual
Page
6
of
11
www.KegLand.com.au
Last Updated 28/07/2021 3:15 PM
Changing the Reservoir Set Temperature on the STC-1000
1.
Hold the
‘
S
’
button until F1 displayed on the screen.
2.
Press
‘
S
’
again which will enter the temperature adjustment mode
3.
Then simultaneously hold
‘
S
’
and the up/down button to alter the set
temperature of the reservoir.
4.
The reservoir set temperature will be saved and the actual measured
temperature of the reservoir will be displayed after a few seconds.
To change any settings on the temperature controller for the reservoir such as
temperature hysteresis or calibration refer to this instruction manual
https://www.kegland.com.au/media/pdf/stc1000%20instructions.pdf
Submersible Pump Temperature Controller Operation
Turning On/Off the Temperature Controllers
To turn the temperature controller On/Off, hold the
‘
Down
’
button for 3 seconds.
Temperature Controller Set Point Adjustment
5.
Hold the
‘
Up
’
button for 3 seconds. A number will begin flashing on the display, this flashing
number is your set temperature.
6.
Press the
‘Down’
button
to decrease the set temperature and press the ‘Up’ button to
increase the set temperature.
Parameter Adjustment
1.
Hold the “Up” and “Down”
buttons simultaneously for 3 seconds. The first menu code FO
will appear on the display.
2.
Press the “Up” or “Down” buttons to cycle through the parameters F0
-F12
3.
Press both the “Up” and “Down” buttons simultaneously to alter the parameter which
appears on the display.
4.
Pres
s the “Up” or “Down” buttons to change the set value of the parameter selected.
If there is no key operation within 5 seconds then the parameter will be set with the displayed value.
The parameters which can be modified are outlined below.