Starter Kit Instruction Manual
Page
4
of
10
www.KegLand.com.au
Last Updated 12/08/2020 9:03 AM
Step-by-step instructions
1.
Assembling the fermenter and other equipment
Once you have unboxed your KegLand 30L Flat-Bottom starter kit and checked everything is
included, begin by assembling your fermenter.
Stick the Stick-On Thermometer onto the outside of the fermenter. We suggest putting it
next to the volume markings between the 10L and 20L markings.
FermZilla – Lid Assembly
1.
Ensure the lid assembly has the o-ring attached.
2.
Apply some food grade lubricant to the o-ring to extend the life of this o-ring and
threads.
3.
Place the lid onto the neck of the tank and screw down the threaded lid ring.
4.
Use the two bottle caps to close the two threaded holes in the lid.
5.
Push the three piece air-lock into remaining (central) hole of the lid
Auto-Siphon Racking Cane and Bottling Wand Assembly
1.
Assemble the siphon by inserting the ball and spring into the siphon tip shown below
(left) and assemble the bottling wand by inserting the spring and pin valve with the
stopper as shown below (middle).
2.
Insert the plastic tube of the bottling wand into the vinyl tube of the Plastic Jiggle
Auto-Siphon Racking cane as shown below (right).
HINT: If it is difficult to insert the bottling wand tube into the vinyl tube try placing the end
of the vinyl tube in warm water to soften the plastic.