www.kegco.com
4
1-888-980-4810
Installation Instructions
BEFORE USE:
•
Remove the exterior and interior packaging.
•
Before connecting the unit to the power source, let it stand upright for approximately 8 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
This appliance is designed for freestanding use. If you are going to put it under a countertop, you must leave 2"
of unobstructed space around the unit for heat dissipation.
•
Place the unit on a flat, solid floor that is strong enough to support it when it is fully loaded. To level the
appliance, adjust the rolling casters at the bottom of the unit.
•
When moving your refrigerator, please do not incline it more than 45 degrees.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption.
•
The refrigerator should be placed in an area where the ambient temperature is less than 100 degrees Fahrenheit
and higher than the lowest temperature you want to store your items at. If the ambient temperature is lower
than the set temperature, the internal temperature will match the ambient temperature.
•
Avoid locating the unit in damp areas.
•
Plug the refrigerator into an exclusive, properly installed and grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or electrical grounding should be directed to a certified electrician or authorized products service center.
•
After plugging the appliance into a wall outlet, allow the unit to cool down for 3 to 4 hours before placing items
in the appliance.
Setting Temperature
The Kegco refrigerator is able to maintain the proper temperature provided it is installed correctly in the proper
environment. The refrigerator should be placed in an area where the ambient temperature range is between 65-80
degrees Fahrenheit. If the ambient temperature is above or below this range, the performance of the unit may be
affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate.
Avoid opening and closing the door of the refrigerator too often to ensure a consistent temperature inside the unit.
To start, turn the temperature control knob to the maximum setting
(6) to achieve coldest position quickly. Allow the unit to run for 48
hours. The temperature range of the thermostat goes from 34°F to
45°F (2.2°C to 7.2°C). Thereafter, adjust the thermostat to desired
temperature range. To turn off the refrigerator, turn the control
knob to the “OFF” position.
There is no need to defrost the refrigerator. Defrost water collects
and passes through the drain outlet in the rear wall into a tray
located above the compressor, where it evaporates.
NOTE:
Keep a thermometer handy and adjust temperature control setting as necessary according to your needs.
If you are going on vacation, you may leave the refrigerator operating during vacations of less than three weeks. If the
appliance will not be used for several months, you should remove all items and turn off the appliance. Clean and dry the
interior thoroughly. To prevent mold growth, leave the door open slightly, blocking it open if necessary.
Содержание MDK-209
Страница 8: ...www kegco com 8 1 888 980 4810...
