Evolution3 SmartFold User Guide –
Care and maintenance
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
[email protected] (UK HQ)
[email protected] (US sales)
Scan the QR code or
click here to view this document online >
Page 6 of 9
There is a small adhesive patch under the left hand end of the
strip to prevent it sliding in use, lift up the strip by sliding a flat
edge under the left hand end of the strip and it should then slide
to the right. A wide bladed flat screwdriver can be used
to help push the strip.
Turn over and re-insert the cutting strip so that the smooth
surface is now facing upwards and what was the left hand
end goes in first. Push it in nearly all the way, again use a flat
edge under the left hand end to raise the strip above the
adhesive patch, when in position press the strip onto the patch to
prevent it sliding.
Should the patch have lost its stickiness, peel it off and replace
with a small piece of double-sided adhesive tape.
Once the strip has been fully used on both sides a new strip will
be required, these are available from your dealer. Keencut part
code EVOTCS
Tip: Order replacement strips (or check stock) whenever turning
a strip over.
