Keeler vantage+, Руководство по обслуживанию

Страница: 13 / 20

V Service Manual
2415-P-7011
Page 11
Issue A 07/07/2008
Refer to figure 1
3. The cable must be a total of 135mm long including the stripped ends from
the Grommet in the Browbar. If a new cable has been fitted
3.1 Trim the cable to 135mm from the grommet.
3.2 Separate the 2 wires for 15mm from the free end
3.3 Strip the covering from the wires for 3mm and tin.
4. Feed the cable through the square slot in the Browbar.
5. Solder the wires carefully to the Dimmer PCB (31). Note the polarity of the
wires when reconnecting the LED version see below. Incorrect
connection may result in damage to the LED.
6. Fit the Dimmer PCB to the Dimmer Control Body (7) and tighten the nut
7. Fit the Dimmer Knob onto the shaft ensuring that the grub screw is
positioned over the flat on the shaft. Tighten the grub screw.
8. Lay the cable along the recess in the Dimmer Body (7) and hook the body
into the Browbar. Fit 3 off No2 x PT Screws (19)