Target group
Knowledge and skills pre-requirement
Start-up technician
Basic technical training (Vocational high school, engineering degree or
corresponding professional experience).
Knowledge in:
●
current valid safety regulations,
●
working mode of machine or plant,
●
principal functions of the application,
●
system analysis and troubleshooting,
●
setting options at the operating installations.
Service technician
Basic technical training (Vocational high school, engineering degree or
corresponding professional experience).
Knowledge in:
●
working mode of a PLC,
●
current valid safety regulations,
●
working mode of machine or plant,
●
diagnosis possibilities,
●
systematic error analysis and rectification.
1.3
Intended use
The CP 263/x was developed for control applications in industrial machines.
The typical applications areas include injection molding machines, robots,
presses, machine tools and similar.
The CP 263/x may only be used for the types of use described in the technical
descriptions and in compliance with described technical general conditions.
The CP 263/x may only be used in conjunction with recommended/approved
third-party equipment/installations.
The CP 263/x has been developed, manufactured, tested and documented in
accordance with the appropriate guidelines and standards. Therefore, the
products do not pose any danger to the health of persons or a risk of damage
to other property or equipment under normal circumstances, provided that the
instructions and safety precautions are properly observed.
1.4
Notes on this document
This manual is an integral part of the product. It is to be retained over the entire
life cycle of the product and should be forwarded to any subsequent owners
or users of the product.
1.4.1
Contents of the document
●
Description of the module
●
Mounting and installation instructions
●
Description of interfaces including EMC guidelines
Introduction
CP 263/S, CP 263/X
© KEBA 2014
Project engineering manual V1.01
10