KEB COMBIVERT P6, Инструкция по эксплуатации

Страница: 45 / 48

45
Annex A
Cycle Function
Annual
Check unit for loose screws and plugs and tighten if necessary.
Clean inverter from dirt and dust deposits. Pay special attention to cooling fins,
fans and protective grids of the fans.
Check and clean inlet and outlet air filters of the control cabinet.
Check function of the fans of the KEB COMBIVERT. The fans must be re-
placed in case of audible vibrations or squeak.
Table 6: Cyclical maintenance
5.5 Fault Remedy
A defective device should only be repaired by KEB or an authorized partner. Defective com-
ponents, modules or options may only be replaced by original parts.
The device must be returned in original packaging with a detailed bug report.
5.6 Disposal
Defective devices which should not be repaired or which are not safe because of their service
life are applied as electronic waste and must be disposed as hazardous waste according to
the local regulations.
5.7 Certification
5.7.1 CE Marking
CE marked frequency inverter and servo drives were developed and manufactured to comply
with the regulations of the Low-Voltage Directive.
The inverter or servo drive must not be started until it is determined that the installation com-
plies with the Machine directive (note EN 60204) as well as the EMC-directive.
The frequency inverters and servo drives meet the requirements of the Low-Voltage Direc-
tive. The harmonized standards of the series EN 61800-5-1 in connection with EN 60439-1
and EN 60146 were used.
This is a product of limited availability in accordance with IEC 61800-3. This product may
cause radio interference in residential areas. In this case the operator may need to take cor-
responding measures.