Keating Of Chicago pre 2000 series, Руководство пользователя

Страница: 9 / 22

1-800-KEATING
|
ELECTRIC GRIDDLE - SERIES PRE-2000
Damage done to the Miraclean® surface is irreparable
and is not covered under Keating Warranty.
B. Limited Calibration (Less than 15°F difference)
You will need: One standard fl at blade screwdriver
One accurate griddle thermometer
1. Set thermostat to 300°F.
2. Allow thermostat to cycle three times.
3. Locate inverted “V” on front of griddle plate above
thermostat to be calibrated to locate thermostat
bulb position. Place thermometer on plate over bulb
half way toward rear of griddle.
4. If calibration of griddle is found to be less than
15°F off, simply loosen three dial plate retaining
screws (See Figure 4-1), rotate dial plate to match
thermometer reading and tighten screws.
NOTE: Calibration is not covered under warranty.
CLEANING
Proper care should be taken to fully clean the griddle
on a regular basis.
DISCONNECT ELECTRIC POWER
SOURCE BEFORE CLEANING.
A. CONTROL PANEL - Clean any
grease build-up on the switches
and thermostat knobs.
NOTE: If grease gets into the body
of the switch or thermostat, it may
cause it to fail.
IF GREASE GETS INTO THE BODY OF THE SWITCH
OR THERMOSTAT, IT MAY CAUSE ELECTRICAL
SHOCK.
B. CABINET - The front, back and
sides of the cabinet should be
kept clean for sanitary and safety
reasons.
See page 5 “Cleaning the Griddle”
7
Figure 4-1
Thermostat Calibration
WARNING
Improper installation
can cause damage,
injury or death.
Shock Burns Gas
WARNING
Disconnect all power
before servicing.
000000