© Copyright 2013 KE2 Therm Solutions, Inc., Washington, Missouri 63090
Quick Start Q.5.24 July 2013
Page 7
KE2
Smart
Gate
Installation and Setup
Network
WAN
7
The Wide Area Network
Address is typically provided by
the device attached to Port 1 on
the KE2 SmartGate. This will either
be the customer’s router or the
ISP’s modem.
By default the KE2 SmartGate is
configured as a DHCP Client. It
will take the address provided
by the DHCP server of the device
attached to the Port 1.
Static IP
8
Some installations may require
setting the WAN IP of the KE2
SmartGate to a specific IP address
provided by the local IT person-
nel or Internet service provider.
To change the KE2 SmartGate
from a dynamic address to a static
address, move the radio button
selection from DHCP to Static. This
will open additional options in the
Quick Start screen.
9
The WAN IP address should be
the 4 IP address octets followed
by the subnet in bits. In smaller
applications it is common to use
an IP address beginning with
192.168.1 with a 24 bit subnet, i.e.
192.168.1.103/24.
10
When changing to a static IP
address, you must also define a
gateway and DNS server(s). These
numbers will be supplied by your
local IT or ISP provider.
11
After successfully configuring
your SmartGate to the appropriate
Static WAN address click the Apply
Configuration button.
8
9
10
11