kdgarden 20’x10’ Carport Canopy Скачать руководство пользователя страница 2

Страница: 2 / 8

READ ALL THE INSTRUCTIONS BEFORE

ASSEMBLY !

Thanks for your purchase of kdgarden Outdoor 20’x10’ Carport Canopy! This unit features

excellent quality and design. It is comprised of a rigid frame and a durable water resistant and

UV-treated cover. To make assembly much easier, all frame parts have been marked with assorted

maintenance.

anchored.

THIS IS A TEMPORARY STRUCTURE AND NOT RECOMMENDED AS A PERMANENT STRUCTURE.

Before your start: 2 or more individuals recommended for assembly.

Allow approximately 15 minutes for every foot in building length.

ATTENTION:

damage caused by sun, light rain, tree sap, animal - bird excrement and light snow. Please anchor

this structure properly. See manual for more anchoring details. Proper anchoring, keeping cover

DANGER:

wires before you dig. DO NOT install near roof lines or other structures that could shed snow, ice

or excessive run oﬀ onto your shelter. DO NOT hang objects from the roof or support cables.

WARNING:

Risk of ﬁre. Do not smoke or use open ﬂame devices (including grills, ﬁre pits, deep fryers, smokers

or lanterns) in or around the shelter. DO NOT store ﬂammable liquids (gasoline, kerosene,

propane, etc.) in or around your shelter. Do not expose top or sides of the shelter to open ﬁre or

other ﬂame source.

Содержание 20’x10’ Carport Canopy





