KDC User Manual A
PPLICATION
G
ENERATION
19
Revision 1.0
Copyright®2012-2015, KOAMTAC, Inc.
user should point the KDC500 at the barcode and press the scan button while trying
the following suggestions:
Modify the angle of the KDC500 in relation to the barcode, making the angle
more wide or narrow as needed.
Modify the distance between the barcode and the KDC500, moving closer or
further away as needed.
Check the option settings defined in the KDC500 menu section and change
options as needed.
Check to see that the barcode’s width does not exceed the light beam’s width,
and vice versa.
Read NFC Tag (MIFARE)
1. The paired host application sends a command to enable the NFC Reader.
2. Touch NFC tag to the NFC antenna symbol on the front case, and make sure
the tag and case are within 4cm of each other.
3. The KDC500 will send the NFC tag UID to the paired host application and
the user will hear a short beep if it has been read successfully.
Read Magnetic-Stripe Card
1. The paired host application sends a command to enable the MS Card Reader.
2. Swipe MS Card either top to bottom or bottom to top. Make sure the
magnetic stripe of the card face to the KDC500.
3. The KDC500 will send the MS card data to the paired host application and
the user will hear a short beep if it has been read successfully.
Read IC Card
1. The paired host application sends a command to enable the IC Card Reader.
2. Insert IC Card to the IC Card Reader located in the left side of KDC500. Make
sure the IC of the card face to up.