|
MIJAR – WATER TREATMENT |
| Azotowa 15b | 41-503 Chorzów | Poland | Tel./fax. 32 2899674 | email: [email protected] | www.mijar.eu |
3. Installation
After preparation for mounting, the device is to be placed in the designated room in accordance with the
system structure.
All inlets and outlets are to be connected on the water’s side. The device connections are shown in the
following figure:
· Connect the inlet (1) and outlet (2) to water supply;
· Connect the elastic pipe (1/2’) draining the sewage to the stub connector pipe (3) and to a sewage
grating or a draining installation.
· The sewage draining should be permeable enough to drain 5l/m of the flushing water. The draining
pipe should be stiff enough to avoid its breaking, which may cause blockage and result in the
overflow in the tank with the reagent as well as faulty regeneration process;
· Before water softener should be used mechanical sediment filter to protect device from mechanical
damage caused by sediments from water pipes.
The brine tank of the water softening device is to be filled with salt tablets (max. filling 100 mm from
the upper edge of the brine tank). Next add 4 liters of water using buckets.
Check and tighten all fittings connecting the device.
Connect to electric Power socket.
The device is factory adjusted.
The water pressure must be at least 2,0 bars and a maximum of 6,0 bars.
Initiate regeneration by pressing
button Y ou will hear the humming of an electric engine, which
means that device driver has started its regeneration. During the regeneration process the system de-
aerates and refills the reagent tank with water. Once the regeneration is over, the device is ready to work
again. During the regeneration hard water is available.
Picture 2. Steering valve description.
1. Inlet of raw water (3/4")
2. Outlet of treated water (3/4")
3. Drain (1/2", elastic connection).
4. 3/8" brine tank connection
4. Maintenance
Refilling the tablet salt:
1. Take off brine tank cover,
2. fill the tank with tablet salt ( max you can place 10 kg of tablet salt inside the tank.)
3. put the brine tank cover back on the right place .
Important: remember that there must be always enough tablet salt In the brine tank to cover the water level.
