V4.00
25833_EDEBD
A0290-0622-1_EN
23
4.1.5 Box-to-Box operation
In Box-to-Box operation, you can establish a logical permanent network connection
between two
multisys D2-ESET -4
serial ports. In this operating mode, there is a perma-
nent online connection between the two serial terminals connected. Possible additional
data traffic or other network protocols do not influence the connection. In this operating
mode, a permanent TCP connection between the server and client port is established.
The server port is acting as a TCP client and thus responsible for opening (after configura-
tion or reset) and closing (after deactivating the „Box-to-Box“ operating mode) tasks.
On the network side, there is only
multisys D2-ESET -4
data traffic using the Box-to-Box
connection if serial reference data is available. There is no data traffic excessing the TCP
protocol.
4.1.6 Setting the multisys D2-ESET -4 in server operation
Example: Server IP address 10.66.22.90
Menu 1 Channel 1
NOTE
For the operating mode „Box-to-Box“, only the server port is configured; The client IP
address (remote IP address) and client port number (remote port) are only set at the
server port!
NOTE
The configuration of the serial interface in the 0 Server sub menu has to be made at
both ports.
Input:
telnet 10.66.22.90 9999
Input: Enter
(within 2 seconds)
Response:
MAC address 00204AA63735
Software version V6.5.0.7 (070919) XPTEXE Press Enter for
Setup Mode
*** basic parameters Hardware: Ethernet TPI
IP addr 10.66.22.90, no gateway set,netmask 255.255.255.0
LAN eBus configuration
