KBL Tower space 2000, Руководство по эксплуатации

Страница: 15 / 56

O p e r a t i n g I n s t r u c t i o n s | KBL tower space 2000
15
5. Start-up
Before switching on for the first time:
• Fix the supplied warning sign or one with the
following wording permanently to the wall close to
the tanning device:
Warning
• UV-radiation can cause eye and skin damage
as well as skin aging and possibly skin cancer.
Ask the studio staff for further information.
• Wear protective goggles.
• Certain medicines or cosmetics can increase
the sensitivity of the skin to UV radiation. If in
doubt, consult a physician.
• Determine the presettings for the device in the
service menu.
• Check correct installation of fluorescent tubes. The
tube labeling must be visible, otherwise no tanning
effect may be obtained.
• Store these Operating Instructions in a place that
allows for easy access at any time.
5.1 Operating modes
The three different operating modes are explained
below:
STANDBY MODE
The tanning device is in an idle state, i.e. it is
connected to the mains but is currently not being
used. The tubes and the tanning lamps are switched
off. From the standby mode, you can change over to
the tanning mode or to the service mode.
TANNING MODE
The tubes and the tanning lamps are switched
on and a tanning session is in progress. While the
tanning device is in tanning mode, the settings for
the ongoing tanning session can be changed via the
interior control panel.
SERVICE MODE
In the service mode, the device is configured for the
tanning mode. Various values can be displayed and
test functions can be carried out.
FAN RUN-ON
After the tanning session, the fan runs on for 3
minutes in order to cool down the device. The fan
power is automatically decreased as the tubes cool
down.