И н с т р у к ц и я п о э к с п л у а т а ц и и
|
space 3000 pureCollagen
37
System messages
ERROR MESSAGES
After the error has been eliminated, all error messages must be acknowledged by pressing
START
on the interior display
.
No.
Status message
Description
Remedy
01
Excess temperature bimetal
Bimetal switch triggers.
Check the air-intake/air-discharge system. Let the sunbed cool
down.
02
Maximum tanning time!
Enabling signal from coin-box system comes
in longer than the time value approved under
“Maximum tanning time” (voltage remains
connected)
Disconnect from the coin-box system.
03
Excess temperature exhaust fan!
Bimetal switch in the fan triggers.
Make sure the fan runs freely. Check the air-intake/air-discharge
system. Let the sunbed cool down.
12
KBL7 Hardware error Input-Con-
troller
Mainboard defective.
Contact your Customer Service.
13
Maximum write cycle fl ash mem-
ory reached
Maximum write cycle fl ash memory reached.
Contact your Customer Service.
14
Error! SD card read error (CRC
fault)
Update via SD card failed (CRC fault).
SD card check / replace.
15
Error! no access to the SD card
Update via SD card failed (access error).
SD card check / replace
17
Parameter storage not found,
please connect and restart
Parameter storage not found, please connect and
restart.
Check connector parameter storage. If necessary replace param-
eter storage.
18
Parameter storage no valid serial
number
Parameter storage no valid serial number.
Contact your Customer Service.
19
CAN-BUS: Interior display V1 is
incompatible
CAN-BUS operators incompatible.
Use CAN-BUS operaters V2.
20
CAN-BUS: preSelection display
V1 is incompatible
21
CAN-BUS: audio module full V1
is incompatible
22
CAN-BUS: RGB module V1 ist in-
compatible
23
Parameter storage write error
Parameter storage write error.
Check connector parameter storage. If necessary replace param-
eter storage.
24
Parameter storage read error
Parameter storage read error.
Check connector parameter storage. If necessary replace param-
eter storage.
25
Frequency detection: detection
failed!
Frequency detection failed.
Restart the controller. Contact your Customer Service after the
third unsuccessful restart.
26
Frequency detection: power sup-
ply connection faulty (connector
X6/E6)!
Frequency detection failed. No mains voltage.
Check mainboard connector X6/E6.
Содержание space 3000 PURECOLLAGEN
