KBL MegaSun K7S, Руководство по эксплуатации

Страница: 10 / 56

Obligations of the studio
operator
The studio operator is responsible
• for informing users about possible risks of tanning.
• for ensuring that all danger and safety instructions
attached to the tanning device are legible, observed
and not removed.
• for ensuring that no safety equipment (e.g. thermal
switches) is removed, deactivated or otherwise
avoided.
• for ensuring that operating, cleaning and mainte-
nance instructions are available.
• for ensuring that the proper handling (use, oper-
ation and maintenance) of the tanning device by
training and instructing the operating personnel.
Operating instructions must enable the
safe operation of the tanning device, tak-
ing into account the national environmen-
tal and occupational health and safety
regulations. Furthermore, they must take
into account special characteristics of the
studio operation and its conclusions.
• In the EU, the EU Directive 89/391/EEC
applies.
• While in Germany, the Industrial Safety
Regulation (BetrSichV) applies.
The manufacturer accepts no liability for damage or
injury resulting from improper handling or non-obser-
vance of these operating instructions.
Only use spare parts approved by KBL! Replace tubes
and high-pressure lamps only with those marked on
the tanning device, otherwise the operating permit
and warranty will expire!
General safety instructions
• This tanning device has been designed for use in a
commercial environment only.
• Observe all instructions in this manual. In addition,
observe all valid legal and other applicable rules
and regulations - including those of the country of
operation.
• The tanning device may only be set up and installed
by trained and authorised specialist personnel.
• Do not make any unauthorised changes or modifi -
cations to the tanning device.
• Observe all danger and safety instructions attached
to the tanning device!
• Do not under any circumstances remove the safety
devices and safety instructions or ignore them!
• Only operate the tanning device when it is in perfect
condition.
• Never operate the tanning device with the external
cladding or acrylic panes removed!
• It is essential to observe the maintenance cycles
specified in the maintenance plan.
• For sunbeds, observe the load limit of the bench
pane.
• The bench may only be opened with the bench pane in
place.
•
The load capacity of the device canopy
is not designed for additional loads.
• Do not lean on or over the canopy of
the device.
Operating instructions | 1/2 | megaSun K5/K6/K7 PRODUCT SERIES
10